![fgtech v54 manual fgtech v54 manual](https://www.u-obd.com/wp-content/uploads/2018/04/FGTech-V54-Galletto-4-BDM-TriCore-OBD-FG-TECH-5.jpg)
Content about different Ecu programmers introduce and reviews, How to use the Ecu chip tuning tool, The software installation and download. The engine management files, refer to the component with “Maps” written next to it or, whenĮ is a Ecu Programmer tech support blog. Note: It is only possible to write the components shown in green. Choose the component to which you want to write the modified file.Remove the check mark from the Restore box.Click on Write to restore the backup file to the ECU.In case you want to work only on theĮngine management files, refer to the component with “Maps” written next to it or, when Note: It is only possible to read the components shown in green. Remove the check mark from the Backup box.Whole backup file, will also propose you to save separate files for each single component so After the Backup, the K-Suite software in addition to saving the Note: As first step, even before read/write the single components of the ECU, you should always Click on Read to get a backup file of all ECU data.Choose the right family by using the Vehicle buttons or the Protocols button.In case of problems or if communication with the ECU is not carried out successfully, beforeĬontacting the Technical Support Service refer to the section Troubleshooting Note: It is possible to perform reading / writing operations even if your computer does not have an This box allows you to save a special file which must be used if you wish to modify the vehicle performance, on pain of improper operation of the vehicle and a possible failure and block of the ECU.
#Fgtech v54 manual serial
For more clarity, the words “Maps” in parentheses is indicated next to the component containing the maps.Ĥ Restore – To restore the backup file on the ECU.ĥ Patch – To enable the serial programming via OBDII on some ECUs (only available for some plug-ins Tricore).Ħ Status bar – Percentage of progress of the read / write procedure.ħ Status window – To display messages about the ongoing operations.Ĩ ID – To display information about the identification of the ECU.ĩ Maps – In some cases, if allowed by the protocol, you can see a white check box labeled “Maps”. It is possible to read/write only the components in green.
![fgtech v54 manual fgtech v54 manual](https://4.bp.blogspot.com/-PXI71QFalm0/WXvb_tWvD2I/AAAAAAAAIVc/dZp9oGXUx7w9hbYvdKAqu9Z5wB8GyUnugCEwYBhgL/s640/install-FgTech-Galletto-4-V54-windows-7-4.jpg)
To read/write a single component, remove the check mark from the Backup/Restore box and select the component. In addition to the whole file, you can also save a file for each component on the ECU and/or the file containing the maps for engine managements.ģ MICRO/EXTFLASH/EEPROM – Components on the ECU. Particularly after each release of the K-Suite softwareĢ Backup – To make a full backup of the ECU data.
#Fgtech v54 manual manuals
It is important to keep the Operating Manuals updated: periodically check for updates, Once back to the previous window, Click on OK to display the programming menu.Connect to the ECU following the connection instructions provided in the Operating Manual.Click on Help for the see the connection instructions.Ktag 7.020 Red PCB Backup, Restore, Read and Write: